Follow these quick steps to start using your gateway integrated payment Ingenico terminal.
1. Verify applicable hardware is included in the shipment.
2. Plug power adapter cable into standard wall outlet. Plug the other end into the Ingenico Cable.
3. Plug the Ingenico Cable ethernet (male end) into router/modem or ethernet hub/switch.
4. Plug the Ingenico Cable HDMI port (single end) into back of the Terminal/PinPad unit.
5. Once unit is powered on and the Everyware logo remains on the screen, the Terminal/PinPad is ready for use on Fortis Gateway and/or integrated solution.
__________________________________________________
Ingenico Payment Terminal Detail Walk Through
1. Verify applicable hardware is included in the shipment. Your shipment should include:
-
Terminal/PinPad Unit
b. Power adapter plug and cable
c. Ingenico cable
2. Plug power adapter cable into standard wall outlet. Plug the other end into the Ingenico Cable.
3. Plug the Ingenico Cable ethernet (male end) into router/modem or ethernet hub/switch.
4. Plug the Ingenico Cable HDMI port (single end) into back of the Terminal/PinPad unit.
The unit will boot up and go through 1-3 boot cycles. Upon completion, the unit will remain on the Everyware logo screen. This process may take several minutes depending on internet connection speeds.
5. Once unit is powered on and the Everyware logo remains on the screen, the Terminal/PinPad is ready for use on Fortis Gateway and/or integrated solution.